Show Your Love of Books with Our Bookcase Refrigerator Skins
Turn your kitchen into a pleasant wood tone library with a magnetic fridge cover Bookcase. Adding a light brown Bookcase skin to your generic refrigerator will make your cooking area as calm as a library. These premium, Bookcase magnet wraps, can easily be installed in minutes, onto your fridge fronts and side panels for a revitalizing new look. Your kitchen deserves a DIY home improvement through an affordable refrigerator magnet panel. For more fun, contrast your Bookcase fridge with a Vintage Books Bookcase dishwasher cover.
Buy a Refrigerator Bookcase Skin Now & Bring a Bit of Quietness into Your Kitchen
Bookcase - High Resolution Printed Image - Made in the USA
- Magnetic Refrigerator Skin Sheet 36” x 65” or 36" x 70"
- One Skin Sheet Completes One Front or One Side
- Skin Fits all Fridge Models Even If Yours is not Shown Above
- You Will Need to Cut Skin Sheet to Fit Your Model of Fridge
- Easy to Cut & Trim with a Box Cutter or Scissors
- Credit Card Thin & Ships Rolled Up in a Tube
- Sticks Instantly & Can Be Removed & Reapplied
- Measure Top to Bottom & Left to Right then Place Order
- Comes with One Page of Easy Instructions
- Product Instructions & Quick Tips Here
United StatesPurchased 3 Refrigerator skins
Love the overall look of these. The problem is that when we trim across the bottom, the print is crooked. Our trim is precise. We trimmed below the door of the bookcase and it is higher on all 3. In other words the part below the door is more on one side than the other side in all 3 skins.
United StatesPretty cool
We have a condo kitchen that is a bit small and the white dishwasher, stove, trash compacter, and refer are boring. We bought this “skin” and it instantly transformed the place into a kind of “nook”. Good graphics, fit great, it looks like the photo. It was **** to put on though. Getting it straight was irritating because the magnet is strong enough that it is impossible to move once it is on so you can’t adjust it. The bottom sticks to the refer as you are lining up the top. Took two people. Cutting the water dispenser was also a challenge and we cut a tiny bit too much, but not noticeable. We didn’t trim the sides. Only stuck out about 1/8th of an inch. Cut with a sharp knife or razor - or scissors pretty easily. The problems were because the thing is made really well and isn’t coming off unless you peel it off. I’d like to figure out how to cover the white handles of my side-by-side though.
Best Appliance Skins
Thank you for the positive feedback. Some Quick Tips. Yes, sometimes it will take two people to get the magnet skin lined up just right. An easy way to cutout for the water dispenser is to leave the magnet skin on the fridge, feel with your hand on the magnet skin for where the water dispenser area is. Then use a box cutter to poke a whole into the middle of the magnet skin of dispenser area. Then run the box cutter along the four edges of the water dispenser for a perfect cutout to the shape of the dispenser. To change the color of the appliance handles first find the screws and remove the handles. Sometimes there is a plug or clip on the handle itself that you will need to pop open with a screwdriver where the screw is located or the screws can also be located at the top and bottom hinges holding the handles onto the door. Then give the handles a light dusting of spray paint, a color of your choice or if the handles can't be removed, tape newspaper to the appliance, covering it, then give the handles a light dusting of spray paint. It is a great way to change the color of the appliance handles. I hope this helps answer your questions.